PNW Moto

PNW Moto (http://pnwmoto.com/pnw-motorcycle-forum.php)
-   Mechanical and Technical (http://pnwmoto.com/mechanical-technical/)
-   -   93 CBR 600F2 2 pin turn signal relay to 3 pin harness (http://pnwmoto.com/mechanical-technical/93-cbr-600f2-2-pin-turn-signal-relay-3-pin-harness-4174/)

cgt1229 Jan 30th 2018 05:10 PM

93 CBR 600F2 2 pin turn signal relay to 3 pin harness
 
Electrical noob wondering how I hook up a 2 pin turn signal relay with a black wire and grey wire to a 3 pin CBR 600F2 connector (from harness) with a 3 pin green, gray & blk/br wire?

It's what came with the bike, looks like a cheap Chinese relay apparently compatible with LED's (12V .05A-10A).

These are cheap stick on signals where the fronts are LED's and the back are just bulbs.
I suppose I could just use bulbs all the way around, but this is the way the bike was set up.

The back of the CBR wiring harness to the rear signals shows a green on both sides, with a orange on the left and a light blue on the right.
If the stick on signals have a black and red wire, do you think the black would connect to the green and the red to either orange or light blue?

Thanks for any help

SXVINWA Jan 30th 2018 07:57 PM

The schematic for a ‘93 shows the flasher wiring to be:

Black - fused power
Green - ground
Grey - power to turn signal switch

Without knowing exactly what the flasher you have is, I’d only be able to make an educated guess that you would want to tie black to black and grey to grey.

As for the signals, I agree that you would tie the black wires of the signals to the harness green wires and red signal wires to the orange and blue harness wires.

cgt1229 Jan 31st 2018 03:36 PM

Quote:

Originally Posted by SXVINWA (Post 43502)
The schematic for a 93 shows the flasher wiring to be:

Black - fused power
Green - ground
Grey - power to turn signal switch

Without knowing exactly what the flasher you have is, Id only be able to make an educated guess that you would want to tie black to black and grey to grey.

As for the signals, I agree that you would tie the black wires of the signals to the harness green wires and red signal wires to the orange and blue harness wires.

Thanks, I'll give that a go.


All times are GMT -8. The time now is 02:51 PM.

Copyright © 2019 PNW Moto. All rights reserved.